Re-Assigned Radio Channels

For the following reasons, I have decided to re-assign my available radio channels:
- I don't plan on installing a gimbal any time soon.
- Mobius camera has it's own battery. Might as well use it.
- I could use some extra FC Aux channels for dedicated Flight Mode switches.

	X8R-RX	APM-FC
RC Cable 1	CH-1 Vertical	CH-1 Vertical
RC Cable 2	CH 2-4 Horizontal (signals only)	CH 2-4 Horizontal (signals only)
RC Cable 3	CH 5-7 Horizontal (signals only)	CH 5-7 (FC Aux 1-3) Horiz
A-Jumper	CH 8	CH 8 (FC Aux 4)
BEC 5v	SBUS

Notes:

• BEC-5v goes to RX and then to FC. FC (Flight Controller) really gets 5v from CH-1 connection.
• Vertical connections are the standard way, with standard RC-Cable radio plug (Gnd, Power, and Signal).
• I used "black to the right" when plugging in horizontal "servo-like" RC Cables.
• A-Jumper is a standard (single-pin) 3inch Arduino Jumper cable
• While Channel-Signal-Rail is on FC bottom, it's on X8R's top (opposite).
• By using previously unused SBUS socket for power, frees a standard channel. It shares the same power-rails.
• At this point, I can't even see a reason to need BEC-5v routed to lower connection panel. If need arises in the future, I can just use a RC Y-cable.

Good pic that someone made.

The white boxes are where you connect Dupont (servo like) RC-Cables. Mine is mostly like this. Only difference is that I went ahead and connected CH-6 also to RX (in case needed later). Red VCC and Black GND drawn boxes are just informational.